Shapes | 793
To Do the following
Adjust the outline opacity In the Stroke area, move the Opacity slider.
Adjust the outline width In the Stroke area, move the Width slider.
Modify the appearance of endpoints of open
shapes
In the Stroke area, click one of the following
Endcap buttons: Projecting , Round , or
Butt .
Modify the appearance of corners where two line
segments connect
In the Stroke area, click one of the following Miter
buttons: Miter , Round , or Bevel .
Set the miter limit to smooth out the sharpness of
lines that join at a sharp angle
Move the Miter Limit slider.
To set shape fill attributes
1
Choose the Shape Selection tool from the toolbox, and click a shape.
You can select multiple shapes by holding down Shift while clicking the shapes.
2 Right-click the shape and choose Set Shape Attributes.
3 In the Shape Attributes dialog box, perform an action from the following table:
To Do the following
Apply a fill Enable the Fill check box.
Remove a fill Disable the Fill check box.
Change the fill color In the Fill area, double-click the color chip and
choose a color from the Color dialog box.
Fill overlapping areas of multiple shapes
Click the Fill Overlaps button.
Hello, im noob :)